Ideal for applique elements, simply apply fusible web to the wrong side of the fabric before cutting to make applique-ready designs straight from the cutter. This die comes complete with detailed instructions on how to make Feathers To GO! table runner. Stylish!
Use the FREE GO! Feathers Embroidery Designs download available to finish your project. Each shape includes motif, blanket and satin stitches.
Cut Size: Curved Feathers: 1 7/16"W x 2 3/4"H (3.7 cm x 7 cm), Straight Feathers: 1 3/8"W x 2 7/16"H (3.5 cm x 6.2 cm)
Finished Size: Curved Feathers: 1 7/16"W x 2 3/4"H (3.7 cm x 7 cm), Straight Feathers: 1 3/8"W x 2 7/16"H (3.5 cm x 6.2 cm)
Die Board Size: 5 in. x 10 in. (12.7 cm x 25.4 cm)
AQ Cutting Mat Required: GO! Cutting Mat, 5 in. x 10 in. (12.7 cm x 25.4 cm)
How to Die Cut Feathers Shapes:
Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué.
- Curved Feathers: Cut and fuse 2" x 3 1/4" rectangles. Cut 12 curved feathers across the width of fabric. One yard of 40" wide fabric cuts 216 curved feathers.
- Straight Feathers: Cut and fuse 1 7/8" x 3" rectangles. Cut 13 straight feathers across the width of fabric. One yard of 40" wide fabric cuts 247 straight feathers.
Why Quilters Love the GO! Feathers Die:
- Feathers have long been a favorite motif for quilters. This die cuts perfect straight and curved feathers that can be used for applique designs, flower petals, angel wings, birds, raindrops and border designs.
- No templates required. The GO! Feathers die includes two shapes that are typically difficult to cut by hand.
- Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric).
- Cut feather shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more!
- A great way to use up scraps.
- Free pattern downloads available to get you started.
- Charm Pack-friendly.
AccuQuilt Benefits:
- Cut so much more fabric in less time.
- Get accurate cuts every time -- No slipping rulers or mistakes
- Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
- Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut.
- Safe to use -- No blades come anywhere near your fingers
Die Tips:
- With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.
- Blades on some dies are positioned at an angle. Align fabric to edge of shape, not edge of die board.
- Use good quality fabric to reduce fabric stretch.
- It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.
