NOTE: This die only works with the GO! Big Electric Fabric Cutter.
Cut Size: 10"W x 10"H (25.4 cm x 25.4 cm)
Finished Size: 9 1/2"W x 9 1/2"H (24.1 cm x 24.1 cm)
Die Board Size: 14 in. x 16 in. (35.6 cm x 40.6 cm)
AQ Cutting Mat Required: GO! Big Cutting Mat, 14 in. x 16 in. (35.6 cm x 40.6 cm)
How to Die Cut 10" Squares:
For best cutting results, position fabric on the lengthwise grain (straight of grain) as it goes under the roller.
- Cut 10 1/2" strips across the width of fabric. Fanfold into 10 1/2" widths. Place on selected blade and cut. Cut three squares across the width of fabric. One yard of 40" wide fabric cuts nine squares.
Why Quilters Love the GO! Big 10" Square Die:
- Quilters love precut 10" squares (aka Layer Cakes) because there are thousands of Layer Cake patterns available to choose from.
- No more purchasing expensive Layer Cakes! The GO! Big Square-10" die is the perfect size to cut your own Layer Cakes with your favorite fabrics or out of larger fabric pieces from your stash. • GO! Big Square-10" includes 1/4" seam allowances for easy alignment and piecing.
- Quilt tops come together quickly and easily making GO! Big Square-10" a great beginner piecing shape and for making simple square quilts for charity.
- Use GO! Big Square-10" to cut larger applique background squares that are all the same size!
- GO! Big Square-10" is a great choice if you want to show off some of your favorite large print or focal fabrics.
- Cut squares out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more!
- A great way to use up scraps.
- Free pattern downloads available to get you started.
- Fat Quarter-friendly.
- Cut so much more fabric in less time.
- Get accurate cuts every time -- No slipping rulers or mistakes
- Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
- Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut.
- Safe to use -- No blades come anywhere near your fingers
- With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.
- Blades on some dies are positioned at an angle. Align fabric to edge of shape, not edge of die board.
- Use good quality fabric to reduce fabric stretch.
- It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.