Use the FREE GO! Leaping Frog Embroidery Designs download available to finish your project. Available in motif, blanket and satin stitches.
Cut Size: Frog: 4 9/16"W x 5"H (11.6 cm x 12.7 cm)
Finished Size: Frog: 4 9/16"W x 5"H (11.6 cm x 12.7 cm)
Die Board Size: 6 in. x 6 in. (15.2 cm x 15.2 cm)
AQ Cutting Mat Required: GO! Cutting Mat, 6 in. x 6 in. (15.2 cm x 15.2 cm)
How to Die Cut Leaping Frog Shapes:
Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué. Place fabric on die right sides together to cut pairs.
- Cut and fuse 5" x 5 1/2" rectangles. Layer on selected blade and cut. Cut eight frogs across the width of fabric. One yard of 40" wide fabric cuts 48 frogs.
Why Quilters Love the GO! Leaping Frog Die:
- Leap into some fun quilt projects with this super cute frog shape. Perfect for baby gifts and children’s projects, as well as whimsical appliqué quilts and home décor.
- No templates required. The GO! Leaping Frog die includes an applique shape that is typically difficult to cut by hand.
- Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric).
- Cut frog shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more!
- A great way to use up scraps.
- Includes free embroidery download with 3 stitches ($12 value).
- Free pattern downloads available to get you started.
- Charm Pack-friendly.
- Cut so much more fabric in less time.
- Get accurate cuts every time -- No slipping rulers or mistakes
- Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
- Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut.
- Safe to use -- No blades come anywhere near your fingers
- With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.
- Blades on some dies are positioned at an angle. Align fabric to edge of shape, not edge of die board.
- Use good quality fabric to reduce fabric stretch.
- It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.